Yes on Mon Jun 08, 2009 5:09 pm
Tazsmonn
Ordered a set in the 90's & they looked just like this.
The Dynaco Tube Audio Forum » Basket » Funky National branded 7199 tube » New post
Options
Topic review
on Sun Jun 07, 2009 10:35 am
Bob Latino
Yes - that small board looks like a custom made 7199 to 6GH8 adapter. As most Dynaco users know there is no direct replacement for a 7199 tube although a 6GH8 or 7687 tube may be used in it's place if a pin adapter is used. Both the 7199 and the 6GH8/7687 have similar characteristics and the the pin out is the same on the triode section on both tubes. The pentode section, however, has a different pin out. Since the 7199 tube is not made any more and as the remaining supply of these tubes slowly dries up, these adapters will become more common. See below for the pentode section pinout differences between the two tubes.
Bob
on Sun Jun 07, 2009 1:33 am
GP49
Never have seen one but I like the circuit board...
Funky National branded 7199 tube on Sun Jun 07, 2009 12:17 am
Sal
This week I received a ST-70 to rebuild. In testing the tubes I found this funky National 7199 tube. Its probably a 6U8 or a 6GH8 with attached printed circuit board swapping the 3 pins.
Did you ever see such a tube? You can see on the top photo the original tube pins are offset to the new pins on the pcb.
Regards,
Sal