The Dynaco Tube Audio Forum

Would you like to react to this message? Create an account in a few clicks or log in to continue.
The Dynaco Tube Audio Forum

Dedicated to the restoration and preservation of all original Dynaco tube audio equipment - Customer support for Tubes4hifi VTA tube amp and preamp kits and all Dynakitparts.com products


2 posters

    MKIII W/VTA high current thru output tubes?

    scott6058
    avatar
    scott6058


    Posts : 37
    Join date : 2009-01-21
    • Post n°1

    MKIII W/VTA high current thru output tubes? Empty MKIII W/VTA high current thru output tubes?

    Post by scott6058 Sun Apr 19, 2009 6:31 pm

    Hello
    I was curious my current thru the output tubes across the 10 ohm resistor at pins 1 & 8 is a bit high 0.58+ volts even with the pots trimmed down. I swapped some rectifier tubes and it made some difference but not much. I just purchased a new set of output tubes and they are the Russian Gold Lion type. Thanks for any help.
    Regards Scott
    • Back to top
    Bob Latino
    Bob Latino
    Bob Latino
    Admin


    Posts : 3262
    Join date : 2008-11-26
    Location : Massachusetts
    • Post n°2

    MKIII W/VTA high current thru output tubes? Empty Re: MKIII W/VTA high current thru output tubes?

    Post by Bob Latino Sun Apr 19, 2009 6:46 pm

    Scott,

    What you need to do is to pull the main bias resistor - the one right next to the silicon diode and replace it with a resistor of a LOWER value. I am not as familiar with the Mark III version of the VTA driver board as I am with the ST-70 version so I don't know what value the resistor is in the Mark III version and I don't know the resistor number? The resistor is right next to the 100 Mfd @ 100 volt capacitor on the bottom of the driver board

    In the meantime running those tubes at .58 volts bias voltage per each KT88 is OK.

    Bob
    • Back to top
      Current date/time is Fri Apr 26, 2024 5:28 pm