does anyone out there have some simple instructions for installing the vta board in my mark III's. i have the fully assembled boards with the wires attached. the instructions that were supplied are for the st-70 more than the mark III. i am new to this and don't want to mess this up.
2 posters
mark III vta install instructions
wedg714- Posts : 74
Join date : 2011-11-23
Roy Mottram- Admin
- Posts : 1838
Join date : 2008-11-30
Similar topics
» Poor man's solid state replacement rectifier for Dynaco ST-70, Mark II, Mark III or Mark IV
» Run your Dynaco ST-70, Mark II, Mark III or Mark IV in TRIODE MODE - photo
» ST-70, Mark II, Mark III and Mark IV - to check your date of manufacture
» Dynakit Mark 3 cage and Dynaco Mark 2 chassis and bottom cover wanted
» On Board Bias Monitoring for Mark III and Mark IV
» Run your Dynaco ST-70, Mark II, Mark III or Mark IV in TRIODE MODE - photo
» ST-70, Mark II, Mark III and Mark IV - to check your date of manufacture
» Dynakit Mark 3 cage and Dynaco Mark 2 chassis and bottom cover wanted
» On Board Bias Monitoring for Mark III and Mark IV