The Dynaco Tube Audio Forum

Would you like to react to this message? Create an account in a few clicks or log in to continue.
The Dynaco Tube Audio Forum

Dedicated to the restoration and preservation of all original Dynaco tube audio equipment - Customer support for Tubes4hifi VTA tube amp and preamp kits and all Dynakitparts.com products


2 posters

    Damaged resistor

    grizzinca
    avatar
    grizzinca


    Posts : 40
    Join date : 2012-01-01
    • Post n°1

    Damaged resistor Empty Damaged resistor

    Post by grizzinca Fri Feb 17, 2012 1:22 am

    Can someone help? I managed to damage one resistor while installing new rca jacks, and would like to know what value resistor to replace both. These are the resistors soldered to the jacks themselves. Seems the color code used back then is somewhat out of date. Thanks
    • Back to top
    Bob Latino
    Bob Latino
    Bob Latino
    Admin


    Posts : 3263
    Join date : 2008-11-26
    Location : Massachusetts
    • Post n°2

    Damaged resistor Empty Re: Damaged resistor

    Post by Bob Latino Fri Feb 17, 2012 7:00 am

    If you have a stock ST-70 those two resistors on the input jacks are 470K (470,000) ohms. Any 1/2 watt or higher resistors will work fine.

    Bob


    Last edited by Bob Latino on Fri Feb 17, 2012 9:00 am; edited 1 time in total
    • Back to top
    grizzinca
    avatar
    grizzinca


    Posts : 40
    Join date : 2012-01-01
    • Post n°3

    Damaged resistor Empty Re: Damaged resistor

    Post by grizzinca Fri Feb 17, 2012 8:50 am

    Thanks Bob. It is stock. Hope to have it up and running this weekend.
    • Back to top
    Sponsored content

    Sponsored content


    • Post n°4

    Damaged resistor Empty Re: Damaged resistor

    Post by Sponsored content

    • Back to top
      Current date/time is Tue May 07, 2024 6:47 pm