The Dynaco Tube Audio Forum

Would you like to react to this message? Create an account in a few clicks or log in to continue.
The Dynaco Tube Audio Forum

Dedicated to the restoration and preservation of all original Dynaco tube audio equipment - Customer support for Tubes4hifi VTA tube amp and preamp kits and all Dynakitparts.com products


2 posters

    PC-3 board resistors

    alyosha
    avatar
    alyosha


    Posts : 32
    Join date : 2012-04-23
    • Post n°1

    PC-3 board resistors Empty PC-3 board resistors

    Post by alyosha Sat Feb 07, 2015 2:56 pm

    Hi,
    As I have some 2W Kiwame resistors left from another project, I was wondering if anyone could tell me if it's possible (any issue?) to use these instead of 1/2W or 1W on the PC-3?
    Thanks in advance for your reply.
    Best regards.
    • Back to top
    DynakitParts
    DynakitParts
    DynakitParts


    Posts : 215
    Join date : 2008-11-30
    • Post n°2

    PC-3 board resistors Empty Resistors

    Post by DynakitParts Sat Feb 07, 2015 3:05 pm

    Hi...
    I see no problem other than the fit on the circuit board. I'm assuming the 2 watt resistors are larger than the original resistors?

    Kevin
    • Back to top
      Current date/time is Fri Nov 22, 2024 11:36 pm