The Dynaco Tube Audio Forum

Would you like to react to this message? Create an account in a few clicks or log in to continue.
The Dynaco Tube Audio Forum

Dedicated to the restoration and preservation of all original Dynaco tube audio equipment - Customer support for Tubes4hifi VTA tube amp and preamp kits and all Dynakitparts.com products


2 posters

    M-125 break-in with Dummy load resistor.

    Beanhead
    avatar
    Beanhead


    Posts : 2
    Join date : 2021-09-09
    • Post n°1

    M-125 break-in with Dummy load resistor. Empty M-125 break-in with Dummy load resistor.

    Post by Beanhead Wed Jan 12, 2022 11:42 am

    Hello,  Does anyone know if it is safe to use a dummy load resistor to break in a newly built M-125's. Would it be safe to run my amps at low to medium volume into a pair of 200watt 8 ohm non inductive resistors? I can't have music playing all the time otherwise I'd just use the speakers!  Thanks for any help.
    • Back to top
    Roy Mottram
    Roy Mottram
    Roy Mottram
    Admin


    Posts : 1839
    Join date : 2008-11-30
    • Post n°2

    M-125 break-in with Dummy load resistor. Empty Re: M-125 break-in with Dummy load resistor.

    Post by Roy Mottram Wed Jan 12, 2022 3:18 pm

    sure, no problem
    • Back to top
    Beanhead
    avatar
    Beanhead


    Posts : 2
    Join date : 2021-09-09
    • Post n°3

    M-125 break-in with Dummy load resistor. Empty Re: M-125 break-in with Dummy load resistor.

    Post by Beanhead Wed Jan 12, 2022 5:15 pm

    Thank you!
    • Back to top
    Sponsored content

    Sponsored content


    • Post n°4

    M-125 break-in with Dummy load resistor. Empty Re: M-125 break-in with Dummy load resistor.

    Post by Sponsored content

    • Back to top
      Current date/time is Mon May 06, 2024 5:54 pm